Step 1 - Read any instructions included FIRST!

Step 2 - Clean your device.

• Ensure the device is switched off and disconnected from any power source.
• The surface that a GrafixSkin sticks to needs to be as clean as possible. It is very important to clean your device before applying your Skin.
• First wipe the device surfaces where the Skin will be applied, with a slightly damp cloth. CAUTION: Do not get water directly on your device.
• Let dry completely.
• Next wipe the application service with the alcohol wipes provided in the box. This removes almost any finger print grease.
• Let your device dry completely for at least 10 Minutes.

Step 3 - Examine Your GrafixSkin.

• Take a look at your GrafixSkin and how it is cut.
• The thin sections easily stretch and/or break if you do not handle the Skin with care.
• Take care when removing from the backing paper.
• Avoid stretching the Skin, especially the narrow parts. Small areas can stretch easily.
• The adhesive side of the Skin can stick to itself and may cause damage to the Skin.

Step 4 - Apply Your GrafixSkin.

• Please take your time when applying your GrafixSkin.
• Pick a starting point on your Skin at the edge (preferably the largest area of the Skin).
• Gradually peel back the backing paper exposing the adhesive side of the GrafixSkin.
• Line it up over the top of your device as closely as possible. A good guide is to find a couple of buttons on your device close together and start applying the Skin there.
• Carefully apply the Skin to the device making sure it lines up with all the openings and curves on your device. Don't apply too much pressure at this point.
• If the Skin does not line up correctly, carefully peel it off and try again. Make sure not to stretch the Skin or it will no longer fit.
• When you are happy with the position, firmly press the Skin from the middle to the edges, pushing any air bubbles out from under the Skin. The air-release adhesive system makes this very easy.
• When applying the Skin to curves or corners you can gently stretch the Skin to get a very tight fit. If you stretch the skin into position, it may require a little heat to enable the edges to conform and adhere correctly.

Please note, that damaged skins caused by user error during the fitting process cannot be replaced.